LSx LS1 LS3 Ignition Coil Relocation Harness Extensions 36″ -Plus MSD Plug Wires

$174.99

Available on backorder

Categories: , , ,

Description

These are our brand new LSx coil pack extension harnesses along with a set of MSD 32079 Gen III LS plug wires.

The coil pack extensions allow you to relocate your ignition coil packs and are approximately 36″ long which gives a good bit of flexibility in mounting locations. Two extensions are included.

The MSD 8.5mm Super Conductor Wire is “the” performance wire.Engineered from the inside out, the 8.5 offers everything you have everwanted in a wire; incredibly low resistance without electronic interference! In a single 12 inch length of Super Conductor Wire there is only 40 – 50 ohms of resistance! That is the lowest resistance of any helically wound wire. To accomplish this, we use a copper alloy conductor due to it’s great voltage carrying capabilities. The low resistance results in less loss in spark energy so more reaches the spark plug. The conductor is wound extremely tight around a special center core. So tight in fact, that there is over 40 feet of conductor wrapped into a single foot of plug wire. This winding procedure, combined with a ferro-magnetic impregnated center core, produces an extremely effective Electro Magnetic Interference (EMI) “choke”. This choke, or suppression capability, keeps the EMI inside the wire where it cannot interfere with other electronics on your vehicle. The outer sleeve that surrounds the conductor assembly is just as impressive. A proprietary blend of silicone and synthetic material produce a sleeve that is highly resistant to high heat as well as abrasion and tears. The MSD 8.5mm Super Conductor Plug Wire is available in Universal Kits and Bulk Lengths.

The wire set comes with both the Multi-angle boots and the 90 degree boots installed. You will have to cut the boot/terminal combination you do not wish to use and install the black LS terminal/boot for the LS coil ends after cutting to the desired length.